Search results
Results from the WOW.Com Content Network
Waterproofing an existing basement begins with excavating to the bottom sides of the footings. Once excavated, the walls are then power washed and allowed to dry. The dry walls are sealed with a waterproofing membrane, [3] and new drainage tiles (weeping tiles) are placed at the side of the footing.
In a masonry cavity wall, there is usually a DPC in both the outer and inner wall. [8] In the outer wall it is normally 150 millimetres (5.9 in) to 200 mm (7.9 in) above ground level (the height of 2-3 brick courses). This allows rain to form puddles and splash up off the ground, without saturating the wall above DPC level.
Damp proofing is another aspect of waterproofing. Masonry walls are built with a damp-proof course to prevent rising damp, and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an ...
A Formosan termite and waterproofing barrier installed on a foundation in Greenville, SC. Applications for termite membranes include on concrete foundation walls, ICF insulated concrete forms, under-slab waterproofing, under-sill plates, flooring underlayments, and as wall, window, and door flashings, among others. Most termite membranes must ...
Cement boards may be classified as water resistant as they are not affected by water exposure; however, they do allow penetration and passage of water and water vapor. To waterproof cement boards, a liquid or membrane waterproofing material is applied over its surface. Cement boards should not be confused with gypsum core backer boards.
Bituminous waterproofing systems are designed to protect residential and commercial buildings. Bitumen (asphalt or coal-tar pitch) is a material made up of organic liquids that are highly sticky, viscous , and waterproof. [ 1 ]
Several layers are used for waterproofing in earth shelter construction. The first layer is meant to seal any cracks or pores in the structural materials, also working as an adhesive for the waterproof membrane. The membrane layer is often a thick flexible polyethylene sheeting called EPDM rubber. EPDM is the material usually used in a water ...
In most climates it is often better to have a vapor-open building assembly, meaning that walls and roofs should be designed to dry: [6] either to the inside, the outside, or both, so the ventilation of water vapor should be taken into consideration. A vapor barrier on the warm side of the envelope must be combined with a venting path on the ...