Search results
Results from the WOW.Com Content Network
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.
The Tomlinson Lumber Co sold pre-cut materials for a 34 by 50 feet (10 m × 15 m) dairy barn with a Gothic-arched roof supported by three-ply rafters in 1958 throughout Minnesota. [ 10 ] The first published plans by an architect for a Gothic-arch barn appeared in 1916.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
A simple rafter roof consists of rafters that the rafter foot rest on horizontal wall plates on top of each wall. [3] The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple.
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
Roof laths span across between the rafters and support the wood shingles. A lath or slat is a thin, narrow strip of straight-grained wood used under roof shingles or tiles, on lath and plaster walls and ceilings to hold plaster, and in lattice and trellis work. [1] Lath has expanded to mean any type of backing material for plaster.