Search results
Results from the WOW.Com Content Network
The tub spout is to be no less than 6 inches and no greater than 11 inches below the valve. If installing a threaded tub spout, connect to the valve with 1/2 inch pipe or 1/2 inch copper tubing with a threaded adapter. If installing a slip-fit tub spout, connect to the valve with only copper tubing – no threaded adapter is needed.
This article will help determine the type of tub spout you are working with and how it is removed. There will be a small hole in the bottom of the tub spout, if you see a screw, you have a CC (Slip Fit) tub spout. If there is no screw, you have an IPS (threaded) tub spout.
https://www.homedepot.ca/product/moen-diverter-tub-spout/1000117455https://www.homehardware.ca/en/slip-fit-tub-diverter-spout/p/3232914
Threaded Tub Spout Installation If this is a shower only installation, skip to step 4.4. IPS (threaded) spouts are designed to screw onto a pipe with 1/2 inch male pipe threads. To determine the proper pipe length, measure from the inside elbow shoulder to the wall (y) and from the threaded adapter inside of the tub spout to the
Screw tub spout onto pipe and tighten by hand. If final turn by wrench is needed, use small wrench with smooth jaws; otherwise, pad wrench teeth with rag as shown.
MOEN TUB SPOUT REPLACEMENTmerch = https://teespring.com/stores/steve-lavhttps://www.patreon.com/stevenlavimonierelavimoniere productions llcsubscribe to my ...
We'll cover everything from shutting off the water supply to your house, carefully removing the old tub and shower valve, and finally, installing your new tub spout.
This article will explain how to identify a Moen tub spout by function, material, length and how it is secured to the wall. You will need to gather the details below before ordering or purchasing a replacement tub spout.
Slip Fit Spouts WITH THE "O"-RING SEAL Lookout must be free from deep scratches, dents, kinks or bends. The cut-off end must be free from burrs inside and out. The edge must not be rolled inward from a dull tubing cutter. The spouts are specifically designed to permit the use of copper water tube on drops and lookouts. FINISHED WALL LINE
Slide the lift rod (#1) through the hole in the top of the spout (#2). The diverter gate (#4) goes into the bottom of the tub spout (#2) with the installed washer (#3) facing the wall. Snap the tabs of the diverter gate (#4) onto the lift rod (#1).