Search results
Results from the WOW.Com Content Network
Note: In this example, "Run" represents the status of a bit in the PLC, while "Motor" represents the actual output to the real-world relay that closes the motor's real-world circuit. For safety reasons, an emergency stop ("ES") may be hardwired in series with the "Start" switch, and the relay logic should reflect this.
Actuator Sensor Interface (AS-Interface or ASi) is an industrial networking solution (Physical Layer, Data access Method and Protocol) used in PLC, DCS and PC-based automation systems. It is designed for connecting simple field I/O devices (e.g. binary ON/OFF devices such as actuators, sensors, rotary encoders, analog inputs and outputs, push ...
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...
Similarly, a parallel set of instructions will perform a logical OR. In an electromechanical relay wiring diagram, a group of contacts controlling one coil is called a "rung" of a "ladder diagram", and this concept is also used to describe PLC logic. Some models of PLC limit the number of series and parallel instructions in one "rung" of logic.
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.
Example Ladder Logic Diagram. The schematic diagrams for relay logic circuits are often called line diagrams, because the inputs and outputs are essentially drawn in a series of lines. A relay logic circuit is an electrical network consisting of lines, or rungs, in which each line or rung must have continuity to enable the output device. A ...
Zero speed switches (ZSS) also known as Speed Actuating Sensing Switches [1] are used to detect whether a rotating shaft is turning (even at very slow speeds) [2] in various machines, conveyors, power plants, and in industries involving the production of cement, sugar, textiles, paper, etc. Zero speed switches mainly use electromechanical, electronic, or magnetic proximity technologies.
Controller Area Network (CAN) – an inexpensive low-speed serial bus for interconnecting automotive components; FlexRay – a general purpose high-speed protocol with safety-critical features; IDB-1394; IEBus; J1708 – RS-485 based SAE specification used in commercial vehicles, agriculture, and heavy equipment.