Search results
Results from the WOW.Com Content Network
Plywood sheet siding is sometimes used on inexpensive buildings, sometimes with grooves to imitate vertical shiplap siding. One example of such grooved plywood siding is the type called Texture 1–11, T1-11, or T111 ("tee-one-eleven").
Metal shakes or shingles. Long life. High cost, suitable for roofs of 3:12 pitch or greater. Because of the flexibility of metal, they can be manufactured to lock together, giving durability and reducing assembly time. For a discussion of copper system shingles, see Copper in architecture#Wall cladding.
Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm (3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm (3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [1]
Poles, from which these buildings get their name, are natural shaped or round wooden timbers 4 to 12 inches (100 to 300 mm) in diameter. [4] The structural frame of a pole building is made of tree trunks, utility poles, engineered lumber or chemically pressure-treated squared timbers which may be buried in the ground or anchored to a concrete slab.
This 5 ⁄ 16 inch (7.9 mm) thick cement board is designed as an underlayment for tile floors. These are 3-by-5-foot (91 by 152 cm) sheets. These are 3-by-5-foot (91 by 152 cm) sheets. A cement board is a combination of cement and reinforcing fibers formed into sheets, of varying thickness that are typically used as a tile backing board. [ 1 ]
Barndominium is derived from using a combination of the words "barn" and "condominium". [4] The original use of the phrase referred to a master-planned development that centered on living near horses. [5] The term was then readopted in the mid-2000s to refer to metal homes that were used as a primary residence.
Typical U.S. height for panels is 8 or 9 feet (2.4 or 2.7 m). Panels come in widths ranging from 4 to 12 inches (100–300 mm) thick and a rough cost is $4–$6/ft 2 in the U.S. [5] In 4Q 2010, new methods of forming radius, sine curve, arches and tubular SIPs were commercialized. Due to the custom nature and technical difficulty of forming and ...
Aircraft plywood is available in thicknesses of 1 ⁄ 8 inch (3 mm) (3-ply construction) and upwards; typically aircraft plywood uses veneers of 0.5 mm (approx 1/64 in) thickness although much thinner veneers such as 0.1 mm are also used in construction of some of the thinner panels.