Search results
Results from the WOW.Com Content Network
Also, in the fall of 1998, GM introduced the C/K crew cab with the 6.5' bed. It was available in the 2500 or 3500 series and two- or four-wheel drive. The 2500 series was available with the 5.7L or 7.4L V8 gasoline engine, or the 6.5L V8 diesel engine, and came with a GVWR of 8,600 pounds.
Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...
Indications of low oil pressure may be that the warning light is on, a low pressure reading on the gauge, or clattering/clinking noises from the engine. Low oil pressure is a problem that must be addressed immediately to prevent serious damage. The leading cause of low oil pressure in an engine is wear on the engine's vital parts.
Chevrolet 153 Inline 4 (Chevy II, pre-Iron-Duke - includes the Vortec 3000/181 industrial/marine crate motor) Detroit Diesel V8 6.2L and 6.5L; Duramax V8; Generation III V8s with modifications. These modifications include an additional bolt hole at the top of the pattern, and attachment points for cast oil pans to lower bellhousing extensions ...
In 1976, the standard gasoline engine for the C-10 became a 2.5L inline-four. [4] A four-cylinder diesel (Perkins 4236 3.8L) was introduced for 1978 in the D10 pickup. [4] For 1981, the engine line was reduced to two, with a 4.1L inline-six becoming offered in gasoline and ethanol-fuel versions (C-10 and A-10) and the Perkins 4236 (D10).
The 90° V6 engine uses the same transmission bellhousing pattern as the Chevrolet small-block V8 engine. The oil pan dipstick is located on the passenger side above the oil pan rail; this design was phased in on both the 90° V6 and Small Block Chevrolet assembly lines (for engines manufactured after 1979) sharing the same casting dies.
The ignition switch was designed to remove power from the vehicle's airbags when in the Off or Accessory mode. [11] Therefore, this was a safety hazard: If the switch changed from Run to Accessory and the vehicle was involved in an accident, it would no longer have power to release the airbags, and it would be difficult for the driver to steer ...
The vast majority of vehicles manufactured after 1987 are fuel-injected: the injectors and high-pressure fuel pump immediately cease supplying fuel to the cylinders when the ignition is switched off. If the injector is damaged or dirty, a small amount of fuel can enter the chamber and be ignited, causing a sputter or two after the engine is ...