Search results
Results from the WOW.Com Content Network
Separately excited DC motors are suitable for control applications because of separate field and armature circuit. [1] Two ways to control DC separately excited motors are: Armature Control and Field Control. [2] A DC motor consists of two parts: a rotor and a stator. [3] The stator consists of field windings while the rotor (also called the ...
A compound DC motor connects the armature and fields windings in a shunt and a series combination to give it characteristics of both a shunt and a series DC motor. [5] This motor is used when both a high starting torque and good speed regulation is needed. The motor can be connected in two arrangements: cumulatively or differentially.
In the armature, an electromotive force is created by the relative motion of the armature and the field. When the machine or motor is used as a motor, this EMF opposes the armature current, and the armature converts electrical power to mechanical power in the form of torque, and transfers it via the shaft. When the machine is used as a ...
A DC motor's speed and torque characteristics vary according to three different magnetization sources, separately excited field, self-excited field or permanent-field, which are used selectively to control the motor over the mechanical load's range. Self-excited field motors can be series, shunt, or a compound wound connected to the armature.
The field coils can be mounted on either the rotor or the stator, depending on whichever method is the most cost-effective for the device design. In a brushed DC motor the field is static but the armature current must be commutated, so as to continually rotate
A growler is an electrical device primarily used for testing a motor for shorted coils. A growler consists of a coil of wire wrapped around an iron core and connected to a source of alternating current. When placed on the armature or stator core of a motor the growler acts as the primary of a transformer and the armature coils act as the ...
A compensation winding in a DC shunt motor is a winding in the field pole face plate that carries armature current to reduce stator field distortion.Its purpose is to reduce brush arcing and erosion in DC motors that are operated with weak fields, variable heavy loads or reversing operation such as steel-mill motors.
Where the 'prime mover' is electrical, a Ward Leonard drive unit consists of a motor and generator with shafts coupled together. The prime mover, which turns at a constant speed, may be AC or DC powered. The generator is a DC generator, with field windings and armature windings. The input to the amplifier is applied to the field windings, and ...