Search results
Results from the WOW.Com Content Network
Length (system unit unit-code symbol or abbrev. notes sample default conversion combination output units SI: megametre: Mm Mm US spelling: megameter 1.0 Mm (620 mi) kilometre
They are typically about 1 inch (25 mm) long. For example, a 1 ⁄ 4-inch to 3 ⁄ 8-inch adapter allows sockets with 1 ⁄ 4-inch drive holes to attach to a 3 ⁄ 8-inch ratchet, and so on. Universal joints are two articulated socket joints (about 1 inch (25 mm) long) combined at a right angle, that allow a bend in the turning axis of the ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
These threads are designated by a number between 1/16 and 6 that originates from the nominal internal diameter (i/d) in inches of a steel pipe for which these threads were designed. These pipe thread designations do not refer to any thread diameter.
ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments. For Morse taper -shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to ...
The design was first proposed by the British Association in 1884 [1] [2] with a thread angle and depth based on the Swiss Thury thread, [3] it was adopted by the Association in 1903. The Thury thread was different in that it went both positive and negative all the way up to a size of −20 which was 75.2 mm diameter by 8.23 mm pitch (p). The ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.