Search results
Results from the WOW.Com Content Network
A growler is an electrical device primarily used for testing a motor for shorted coils. A growler consists of a coil of wire wrapped around an iron core and connected to a source of alternating current. When placed on the armature or stator core of a motor the growler acts as the primary of a transformer and the armature coils act as the ...
In the armature, an electromotive force is created by the relative motion of the armature and the field. When the machine or motor is used as a motor, this EMF opposes the armature current, and the armature converts electrical power to mechanical power in the form of torque, and transfers it via the shaft. When the machine is used as a ...
YASA Limited (formerly YASA Motors Limited) was founded in September 2009 to commercialise a permanent-magnet axial-flux electric motor (YASA stands for Yokeless and Segmented Armature). The motor was developed for the Morgan LIFEcar in 2008 by Dr Malcolm McCulloch and Dr Tim Woolmer, then a PhD student, at the University of Oxford.
The Thunderjet could outperform contemporary inlines primarily because the vertical-shaft layout allowed the bulky motor magnets to be mounted to the front and rear, which left the full width of the chassis for the armature and windings. Inline motors require side-mounted magnets, limiting the size of both armature and magnets.
Baldor Electric was founded in 1920 by Edwin Ballman and Emil Doerr. The name of the company was derived using part of each of their names. In 1967 the Company's headquarters were moved from St. Louis, Missouri to Fort Smith, Arkansas. In 2007, Baldor Electric acquired the Dodge and Reliance Electric brands from Rockwell Automation for $1.8 ...
The first experimental electric traction motor tramway of 1875 was rapidly developed internationally for city use. [5] [6] [7] In the 19th century traction motor passenger car companies began to compete with the dominant citywide horse-drawn railway transportation system. [8] [9] [10]
Armature control is the most common control technique for DC motors. In order to implement this control, the stator flux must be kept constant. To achieve this, either the stator voltage is kept constant or the stator coils are replaced by a permanent magnet .
This is done by supplying the armature windings on the rotor through a commutator, a combination of rotating slip ring and switches. AC induction motors also use field coils on the stator, the current on the rotor being supplied by induction in a squirrel cage. For generators, the field current is smaller than the output current.