enow.com Web Search

  1. Ads

    related to: 4 1/2 inch baseboard molding

Search results

  1. Results from the WOW.Com Content Network
  2. Baseboard - Wikipedia

    en.wikipedia.org/wiki/Baseboard

    Baseboard. In architecture, a baseboard (also called skirting board, skirting, wainscoting, mopboard, trim, floor molding, or base molding) is usually wooden, MDF or vinyl board covering the lowest part of an interior wall. Its purpose is to cover the joint between the wall surface and the floor. It covers the uneven edge of flooring next to ...

  3. Cross-linked polyethylene - Wikipedia

    en.wikipedia.org/wiki/Cross-linked_polyethylene

    A cross-linked polyethylene (PEX) pipe. Cross-linked polyethylene, commonly abbreviated PEX, XPE or XLPE, is a form of polyethylene with cross-links.It is used predominantly in building services pipework systems, hydronic radiant heating and cooling systems, domestic water piping, insulation for high tension (high voltage) electrical cables, and baby play mats.

  4. Molding (decorative) - Wikipedia

    en.wikipedia.org/wiki/Molding_(decorative)

    Molding (decorative) Moulding (British English), or molding (American English), also coving (in United Kingdom, Australia), is a strip of material with various profiles used to cover transitions between surfaces or for decoration. It is traditionally made from solid milled wood or plaster, but may be of plastic or reformed wood.

  5. Reveal (carpentry) - Wikipedia

    en.wikipedia.org/wiki/Reveal_(carpentry)

    Reveal (carpentry) In carpentry, a reveal is a feature resembling a rabbet, but constructed of separate pieces of wood. A reveal may typically be seen at the edge of a door or window, where the face molding is set back, often by a distance from 3/16" (5 mm) to 1/2" (12 mm). (This noun is unrelated to the verb reveal but is from the obsolete ...

  6. Permanent mold casting - Wikipedia

    en.wikipedia.org/wiki/Permanent_mold_casting

    Typical tolerances are 0.4 mm for the first 25 mm (0.98 in) for the first inch) and 0.02 mm for each additional centimeter (0.002 in per in); if the dimension crosses the parting line add an additional 0.25 mm (0.0098 in). Typical surface finishes are 2.5 to 7.5 μm (100–250 μin) RMS. A draft of 2 to 3° is required.

  7. Quarter round - Wikipedia

    en.wikipedia.org/wiki/Quarter_round

    Quarter round molding at the edge of a parquet floor. A quarter round is a convex molding whose cross section is a quarter circle. It is one form of ovolo . A variation is a base shoe, a quarter of an ellipse. [1] Most quarter round is of small gauge and relatively flexible. It is typically used as a decorative build-up element in mantels and ...

  1. Ads

    related to: 4 1/2 inch baseboard molding