Search results
Results from the WOW.Com Content Network
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
Template {} converts a value from one unit of measurement to another. This page documents some features of units, and lists units that are commonly used in conversions. This page documents some features of units, and lists units that are commonly used in conversions.
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
If a problem cannot readily be resolved, please report it at one of the following. Template talk:Convert • Questions on using the convert template, or discussion of any problems encountered; Wikipedia:Help desk • General questions; Module talk:Convert • Discussion concerning the convert modules
The Extra column is usually empty, but can contain a value or code when more than a simple Scale is required for a conversion. There are two codes used with fuel efficiency units: volume/length and length/volume. In addition, certain codes are required to indicate that the conversion procedure for the unit is built-in to the module.
By {{Convert}} default, the conversion result will be rounded either to precision comparable to that of the input value (the number of digits after the decimal point—or the negative of the number of non-significant zeroes before the point—is increased by one if the conversion is a multiplication by a number between 0.02 and 0.2, remains the ...
True RMS provides a more correct value that is proportional to the square root of the average of the square of the curve, and not to the average of the absolute value. For any given waveform, the ratio of these two averages is constant and, as most measurements are made on what are (nominally) sine waves, the correction factor assumes this ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.