Search results
Results from the WOW.Com Content Network
Italian physicist and electrical engineer Galileo Ferraris publishes a paper on the induction motor, and Serbian-American engineer Nikola Tesla gets a US patent on the same device [4] [5] 1890: Thomas Alva Edison invents the fuse: 1893: During the Fourth International Conference of Electricians in Chicago, electrical units were defined 1893
Ohm's law states that the electric current through a conductor between two points is directly proportional to the voltage across the two points. Introducing the constant of proportionality, the resistance, [1] one arrives at the three mathematical equations used to describe this relationship: [2]
Dynamic (electrical overhead-)line rating is a great opportunity for transmission line operators (any voltage from 15 kV to 735 kV and over). It has been studied for more than 20 years inside CIGRE and IEEE working groups.
Also called chordal or DC resistance This corresponds to the usual definition of resistance; the voltage divided by the current R s t a t i c = V I. {\displaystyle R_{\mathrm {static} }={V \over I}.} It is the slope of the line (chord) from the origin through the point on the curve. Static resistance determines the power dissipation in an electrical component. Points on the current–voltage ...
Electrical resistivity (also called volume resistivity or specific electrical resistance) is a fundamental specific property of a material that measures its electrical resistance or how strongly it resists electric current. A low resistivity indicates a material that readily allows electric current.
A Smith chart to calculate electrical impedance with no values plotted; although not a nomogram, it is based on similar principles. Like a slide rule, a nomogram is a graphical analog computation device. Also like a slide rule, its accuracy is limited by the precision with which physical markings can be drawn, reproduced, viewed, and aligned.
The power dissipated by a resistor may be calculated from its resistance, and the voltage or current involved. The formula is a combination of Ohm's law and Joule's law: = = =, where P is the power, R is the resistance, V is the voltage across the resistor, and I is the current through the resistor.
It may also vary with time (most often decreasing) in a process known as resistance creep. Electrical contact resistance is also called interface resistance, transitional resistance, or the correction term. Parasitic resistance is a more general term, of which it is usually assumed that contact resistance is a major component.