enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Typographic unit - Wikipedia

    en.wikipedia.org/wiki/Typographic_unit

    The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...

  3. Linear congruential generator - Wikipedia

    en.wikipedia.org/wiki/Linear_congruential_generator

    The second row is the same generator with a seed of 3, which produces a cycle of length 2. Using a = 4 and c = 1 (bottom row) gives a cycle length of 9 with any seed in [0, 8]. A linear congruential generator (LCG) is an algorithm that yields a sequence of pseudo-randomized numbers calculated with a discontinuous piecewise linear equation.

  4. Point (typography) - Wikipedia

    en.wikipedia.org/wiki/Point_(typography)

    A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [ 27 ] [ 33 ] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry.

  5. Digital card - Wikipedia

    en.wikipedia.org/wiki/Digital_card

    The magnetic stripe is located 0.223 inches (5.7 mm) from the edge of the card, and is 0.375 inches (9.5 mm) wide. The magnetic stripe contains three tracks, each 0.110 inches (2.8 mm) wide. Tracks one and three are typically recorded at 210 bits per inch (8.27 bits per mm), while track two typically has a recording density of 75 bits per inch ...

  6. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  7. Safety fuse - Wikipedia

    en.wikipedia.org/wiki/Safety_fuse

    It was supplied as a "rope" of about 0.375 to 0.5 inches (9.5 to 12.7 mm) diameter; and was sold at the time for about same price as its predecessor, quills, at three pence per fathom (6 ft, 1.8 m). [6] Bickford also set up a partnership with Thomas Davey, who gained twenty five percent of the profits for the first fourteen years. [6]

  8. Number Forms - Wikipedia

    en.wikipedia.org/wiki/Number_Forms

    Number Forms is a Unicode block containing Unicode compatibility characters that have specific meaning as numbers, but are constructed from other characters. They consist primarily of vulgar fractions and Roman numerals .

  9. M10 tank destroyer - Wikipedia

    en.wikipedia.org/wiki/M10_tank_destroyer

    The side and rear upper hull armor of the T35E1 was reduced from 1 inch (25 mm) to 0.75 inches (19 mm) in order to reduce the weight of the vehicle. The staff at Aberdeen Proving Ground was worried that the armor of the T35E1 was too thin, and so bosses for appliqué armor panels were added to the hull sides, glacis , and turret sides.