enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Television antenna - Wikipedia

   en.wikipedia.org/wiki/Television_antenna

   A Winegard 68 element VHF/UHF aerial antenna. This common multi-band antenna type uses a UHF Yagi at the front and a VHF log-periodic at the back coupled together. When a higher-gain antenna is needed to achieve adequate reception in suburban or fringe reception areas, an outdoor directional antenna is usually used.

3. 4G-LTE filter - Wikipedia

   en.wikipedia.org/wiki/4G-LTE_filter

   Thus, the frequency band dedicated to TV became between 470 MHz and 700 MHz (channels 14-52), whilst 4G LTE uses the frequency bands between 700 and 900 MHz (former TV channels 52 to 83), resulting in an interval separating the two bands (DTT and 4G) of about 1 MHz, so that there is a risk of interference [1] in the areas close to the 4G-LTE ...

4. UHF television broadcasting - Wikipedia

   en.wikipedia.org/wiki/UHF_television_broadcasting

   TV antenna manufacturers often rated their top-of-the-line "deep-fringe" antenna models with phrases like "100 miles VHF/60 miles UHF" if the antenna included UHF reception at all. (In the practice of electrical engineering, the frequency range in which an antenna is to be used is an important factor in its design.)

5. Long-range Wi-Fi - Wikipedia

   en.wikipedia.org/wiki/Long-range_Wi-Fi

   Long-range Wi-Fi especially in the 2.4 GHz band (as the shorter-range higher-bit-rate 5.8 GHz bands become popular alternatives to wired LAN connections) have proliferated with specialist devices. While Wi-Fi hotspots are ubiquitous in urban areas, some rural areas use more powerful longer-range transceivers as alternatives to cell ( GSM , CDMA ...

6. The 7 Best HDTV Antenna Amplifiers of 2023 For a Better Signal

   www.aol.com/lifestyle/best-high-definition-tv...

   8-Port TV Distribution Amplifier. For households with multiple TVs, the Antennas Direct 8-Port TV Distribution Amplifier can split a signal with no noticeable impact on signal quality.

7. Reflective array antenna - Wikipedia

   en.wikipedia.org/wiki/Reflective_array_antenna

   In order for the signals to add together, they need to arrive in-phase.Consider two dipole antennas placed in a line end-to-end, or collinear.If the resulting array is pointed directly at the source signal, both dipoles will see the same instantaneous signal, and thus their reception will be in-phase.