enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nissan Z engine - Wikipedia

   en.wikipedia.org/wiki/Nissan_Z_engine

   All Z engines had 4 cylinders, a total of 8 valves and a single overhead camshaft . Displacements ranged from 1.6 L to 2.4 L.The Z series' engine blocks were nearly identical to those of the earlier L Series with the exception of the Z24. While the Z16 and Z18 engines had a deck height similar to the earlier L13/L14/L16/L18 variants, the Z24 ...

3. List of Isuzu engines - Wikipedia

   en.wikipedia.org/wiki/List_of_Isuzu_engines

   The DL200 is a long-stroke 2.0L engine with cast iron block and head. It was fitted to the Isuzu Elf. In 1961 it was replaced by the more modern DL201 engine. 79 mm (3.1 in) 107 mm (4.2 in) 1,999 cc (122.0 cu in) 52 PS (38 kW) 12 kg⋅m (120 N⋅m; 87 lb⋅ft) 8 Valve OHV There is also a 1.6L engine with cast iron block and head.

4. List of GM bellhousing patterns - Wikipedia

   en.wikipedia.org/wiki/List_of_GM_bellhousing...

   The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...

5. Willys Hurricane engine - Wikipedia

   en.wikipedia.org/wiki/Willys_Hurricane_engine

   This allowed the valves to be larger and the combustion chamber to be smaller, improving flow and increasing the compression ratio. [2] The compression ratio rose from 6.5:1 in the Go-Devil engine to 7.5:1 in the Hurricane engine, although a version of the Hurricane engine was made with a 6.9:1 compression ratio. [3]

6. List of Ford bellhousing patterns - Wikipedia

   en.wikipedia.org/wiki/List_of_Ford_bellhousing...

   Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and ...

7. Chevrolet 153 4-cylinder engine - Wikipedia

   en.wikipedia.org/.../Chevrolet_153_4-cylinder_engine

   The 153 cu in engine had a 3 + 7 ⁄ 8-inch (98 mm) bore and 3 + 1 ⁄ 4-inch (82.6 mm) stroke, with two overhead valves per cylinder actuated by pushrods and a 1-3-4-2 firing order. The Chevy II 's 194 cu in six-cylinder used a 3 + 9 ⁄ 16 -inch (90.5 mm) bore, which by 1964 was enlarged to match the 153 four-cylinder's resulting in a ...