Search results
Results from the WOW.Com Content Network
Amorphous silicon (a-Si) is the non-crystalline form of silicon used for solar cells and thin-film transistors in LCDs.. Used as semiconductor material for a-Si solar cells, or thin-film silicon solar cells, it is deposited in thin films onto a variety of flexible substrates, such as glass, metal and plastic.
Polycrystalline silicon (p-Si) is a pure and conductive form of the element composed of many crystallites, or grains of highly ordered crystal lattice.In 1984, studies showed that amorphous silicon (a-Si) is an excellent precursor for forming p-Si films with stable structures and low surface roughness. [2]
As a material transitions from the amorphous state to the fully crystalline state, the broad maximum sharpens up and other sharp peaks start to appear in the n(λ) and k(λ) spectra. This is demonstrated for the case of amorphous silicon progressing to poly-silicon and further progressing to crystalline silicon.
Because it is naturally abundant and well understood, amorphous or polycrystalline silicon were (and still are) used as the semiconductor layer. However, because of the low mobility of amorphous silicon [ 2 ] and the large device-to-device variations found in polycrystalline silicon, [ 3 ] [ 4 ] [ 5 ] other materials have been studied for use ...
The piezoresistive effect of semiconductor materials can be several orders of magnitudes larger than the geometrical effect and is present in materials like germanium, polycrystalline silicon, amorphous silicon, silicon carbide, and single crystal silicon. Hence, semiconductor strain gauges with a very high coefficient of sensitivity can be built.
Download as PDF; Printable version; ... move to sidebar hide. Amorphous semiconductor may refer to : Amorphous silicon (e.g. for thin-film PV) glassy ...
The Federal Reserve's rate cuts won't directly lower home prices in 2025. But they could spur a chain reaction that leads to a drop in home prices. The Fed doesn't set mortgage rates or any other ...
Amorphous steel is limited to foils of about 50 μm thickness. The mechanical properties of amorphous steel make stamping laminations for electric motors difficult. Since amorphous ribbon can be cast to any specific width under roughly 13 inches and can be sheared with relative ease, it is a suitable material for wound electrical transformer cores.