Search results
Results from the WOW.Com Content Network
A patch antenna is a narrowband, wide-beam antenna fabricated by etching the antenna element pattern in metal trace bonded to an insulating dielectric substrate, such as a printed circuit board, with a continuous metal layer bonded to the opposite side of the substrate which forms a ground plane. Common microstrip antenna shapes are square ...
An antenna like effect is achieved by periodic swing of electrons from its capacitive element to the ground plane which behaves like an inductor. The authors further argued that the operation of a dielectric antenna resembles the antenna conceived by Marconi, the only difference is that inductive element is replaced by the dielectric material. [5]
Stubs are commonly used in antenna impedance matching circuits, frequency selective filters, and resonant circuits for UHF electronic oscillators and RF amplifiers. Stubs can be constructed with any type of transmission line: parallel conductor line (where they are called Lecher lines), coaxial cable, stripline, waveguide, and dielectric waveguide.
Cross-section of microstrip geometry. Conductor (A) is separated from ground plane (D) by dielectric substrate (C). Upper dielectric (B) is typically air. Microstrip is a type of electrical transmission line which can be fabricated with any technology where a conductor is separated from a ground plane by a dielectric layer known
Dielectric resonators' main use is in millimeter-wave electronic oscillators (dielectric resonator oscillator, DRO) to control the frequency of the radio waves generated. They are also used as bandpass filters as well as antennas .
The dielectric losses depend only on the substrate and not on the geometry: unlike the conduction losses, is not influenced by the substrate thickness. It transpires that the only way to reduce α D {\displaystyle \alpha _{D}} consists in choosing a template with better dielectric properties: the lower the loss tangent tan δ {\displaystyle ...
An antenna array (or array antenna) is a set of multiple connected antennas which work together as a single antenna, to transmit or receive radio waves. [ 1 ] : p.149 [ 2 ] The individual antennas (called elements ) are usually connected to a single receiver or transmitter by feedlines that feed the power to the elements in a specific phase ...
A patch antenna is a type of antenna with a low profile, usually consisting of a printed circuit board. It consists of a planar rectangular or circular sheet or "patch" of metal, mounted over a larger sheet of metal called a ground plane. It is the original type of microstrip antenna described by Howell in 1972. [1]