Search results
Results from the WOW.Com Content Network
Hydroforming is capable of producing parts within tight tolerances including aircraft tolerances where a common tolerance for sheet metal parts is within 0.76 mm (1/30th of an inch). Metal hydroforming also allows for a smoother finish as draw marks produced by the traditional method of pressing a male and female die together are eliminated.
It typically begins with a large coil of sheet metal, between 1 inch (2.5 cm) and 20 inches (51 cm) in width, and 0.004 inches (0.10 mm) and 0.125 inches (3.2 mm) thick, supported on an uncoiler. The strip is fed through an entry guide to properly align the material as it passes through the rolls of the mill, each set of rolls forming a bend ...
For thin sheet metal with a thickness less than 200 μm (0.0079 in), [citation needed] the rolling is done in a cluster mill because the small thickness requires a small diameter rolls. [10] To reduce the need for small rolls pack rolling is used, which rolls multiple sheets together to increase the effective starting thickness.
A tandem rolling mill is a rolling mill used to produce wire and sheet metal. It is composed of two or more close-coupled [clarification needed] stands, and uses tension between the stands as well as compressive force from work rolls [clarification needed] to reduce the thickness of steel. It was first patented by Richard Ford in 1766 in England.
A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [21]
Fig. 1. A shear formed product: a hollow cone with a thin wall thickness. Shear forming, also referred as shear spinning, is similar to metal spinning. In shear spinning the area of the final piece is approximately equal to that of the flat sheet metal blank. The wall thickness is maintained by controlling the gap between the roller and the ...
When rolling, the top roll presses the metal plate between the two side rolls. The advantage of having the variable three roll is the ability to roll many thicknesses and diameters of cylinders. For example; The side-rolls are what produce the mechanical advantage. With the side rolls all the way open, one has the maximum mechanical advantage ...
Drawing metal requires finding the correct balance between wrinkles and breaking to achieve a successful part. Sheet metal drawing becomes deep drawing when the workpiece is longer than its diameter. It is common that the workpiece is also processed using other forming processes, such as piercing, ironing, necking, rolling, and beading. In ...