Search results
Results from the WOW.Com Content Network
Fox 34, travel 120-140mm for cross country and light trail use Fox 36, travel 150-160mm for trail and enduro use Fox 38, travel 160-180mm for hard enduro use Fox 40, travel 203mm for downhill use (only dual crown fork) As of January 2025 the available rear shocks are: Fox Float SL, for cross country use Fox Float, for trail and cross country use
There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs. The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles.
The Dana 44 Front axle first saw use in the 1950s and still in use today. Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks.
The Dana/Spicer model 53 is an automotive rear axle produced by Dana-Spicer used in medium to heavy duty truck applications. The Dana/Spicer model 53 (Dana 53) is a semi-float axle that was produced from 1947–1965, [1] both with a 53 differential and wheel ends, and with a Dana 44 differential and Dana 53 wheel ends.
Although this axle is designed for medium-duty, commercial-trucks, Ford did put the S110 in 2008-2010 & 2015-2016 F-450 Pick up trucks. The Dana S110 has a GAWR up to 14,706 lbs but is frequently, de-rated by vehicle manufacturer for safety and tire reasons. This axle is not used in 1 Ton trucks . Dana S110 in a 2008 Ford F-450 Cab/Chassis
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep