enow.com Web Search

  1. Ads

    related to: sag correction chart for concrete cracks in basement

Search results

  1. Results from the WOW.Com Content Network
  2. Crack spacing of reinforced concrete - Wikipedia

    en.wikipedia.org/wiki/Crack_spacing_of...

    When a reinforced concrete member is put in tension, after cracking, the member elongates by widening of cracks and by formation of new cracks. Figure 1 Formation of internal cracks. Ignoring the small elastic strain in the concrete between the cracks, we can relate the crack width to the strain of the member by:

  3. Tape correction (surveying) - Wikipedia

    en.wikipedia.org/wiki/Tape_correction_(surveying)

    A tape not supported along its length will sag and form a catenary between end supports. According to the section of tension correction some tapes are calibrated for sag at standard tension. These tapes will require complex sag and tension corrections if used at non-standard tensions.

  4. Fracture mechanics - Wikipedia

    en.wikipedia.org/wiki/Fracture_mechanics

    Concrete fracture analysis is part of fracture mechanics that studies crack propagation and related failure modes in concrete. [17] As it is widely used in construction, fracture analysis and modes of reinforcement are an important part of the study of concrete, and different concretes are characterized in part by their fracture properties. [ 18 ]

  5. Marcus' method - Wikipedia

    en.wikipedia.org/wiki/Marcus'_method

    Marcus's method is a structural analysis used in the design of reinforced concrete slabs.The method was developed by Henri Marcus and described in 1938 in Die Theorie elastischer Gewebe und ihre Anwendung auf die Berechnung biegsamer Platten. [1]

  6. Hogging and sagging - Wikipedia

    en.wikipedia.org/wiki/Hogging_and_sagging

    Hogging is the stress a ship's hull or keel experiences that causes the center or the keel to bend upward. Sagging is the stress a ship's hull or keel is placed under when a wave is the same length as the ship and the ship is in the trough of two waves.

  7. Cascade chart (NDI interval reliability) - Wikipedia

    en.wikipedia.org/wiki/Cascade_chart_(NDI...

    The process for creating the cascade chart shown on the right begins with modeling the crack growth over a time interval, number of cycles, or number of flight hours. Based on an initial crack size, a i, the crack growth curve can vary significantly, causing the crack to reach its critical size in different lengths of time. This contributes to ...

  1. Ads

    related to: sag correction chart for concrete cracks in basement