Search results
Results from the WOW.Com Content Network
The glowing splint test is a test for an oxidising gas, such as oxygen. [4] In this test, a splint is lit, allowed to burn for a few seconds, then blown out by mouth or by shaking. Whilst the ember at the tip is still glowing hot, the splint is introduced to the gas sample that has been trapped in a vessel. [4]
Dynasplint Systems, Incorporated (DSI) is a company that designs, manufactures and sells dynamic splints that are used for range of motion rehabilitation. The corporate headquarters are located in Severna Park, Maryland and it is considered a major employer in Anne Arundel County. [1]
A gas bubbler is a piece of laboratory glassware which consists of a glass bulb filled with a small amount of fluid—usually mineral or silicone oil, less commonly mercury. The inlet to the bulb is connected to a ground glass joint, while the outlet is vented to the air. Gas bubblers are used to exclude air from a reaction or a system.
The gas in a glovebox is pumped through a series of treatment devices which remove solvents, water and oxygen from the gas. Copper metal (or some other finely divided metal) is commonly used to remove oxygen, this oxygen removing column is normally regenerated by passing a hydrogen/nitrogen mixture through it while it is heated: the water formed is passed out of the box with the excess ...
A traction splint most commonly refers to a splinting device that uses straps attaching over the pelvis or hip as an anchor, a metal rod(s) to mimic normal bone stability and limb length, and a mechanical device to apply traction (used in an attempt to reduce pain, realign the limb, and minimize vascular and neurological complication) to the limb.
Crude versions of conically tapered ground glass joints have been made for quite a while, [1] particularly for stoppers for glass bottles and retorts. [2] Crude glass joints could still be made to seal well by grinding the two parts of a joint against each other using an abrasive grit, but this led to variations between joints and they would not seal well if mated to a different joint.
The prepared gas is usually impure, contaminated with fine aerosol of the reagents and water vapor. The gases may need to be filtered, washed and dried before further use. Hydrogen can be washed from sulfane, arsine and oxygen with subsequent bubbling through solutions of lead acetate , silver nitrate , and alkaline pyrogallic acid .
As the NTI-TSS does not cover all of the teeth, it is classed as a partial coverage occlusal splint. Partial coverage splints are recommended by some experts, but they have the potential to cause unwanted tooth movements if worn 24 hours a day 7 days a week with no tooth contact (which is never recommended), [14] which rarely can be severe.