Search results
Results from the WOW.Com Content Network
SFM is a combination of diameter and the velocity (RPM) of the material measured in feet-per-minute as the spindle of a milling machine or lathe. 1 SFM equals 0.00508 surface meter per second (meter per second, or m/s, is the SI unit of speed). The faster the spindle turns, and/or the larger the diameter, the higher the SFM.
1 / 60 Hz = 0.01 6 Hz. SI base units. 0.01 6 s −1. Revolutions per minute (abbreviated rpm, RPM, rev/min, r/min, or r⋅min−1) is a unit of rotational speed (or rotational frequency) for rotating machines. One revolution per minute is equivalent to 1 60 hertz.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
Expressed in metric units, the "specific speed" is ns = 0.2626 n √P / h5/4. where n is the wheel speed in rpm. P is the power in kilowatts. h is the water head in meters. The factor 0.2626 is only required when the specific speed is to be adjusted to English units.
Rotational frequency, also known as rotational speed or rate of rotation (symbols ν, lowercase Greek nu, and also n), is the frequency of rotation of an object around an axis. Its SI unit is the reciprocal seconds (s −1 ); other common units of measurement include the hertz (Hz), cycles per second (cps), and revolutions per minute (rpm).
Affinity laws. The affinity laws (also known as the "Fan Laws" or "Pump Laws") for pumps/fans are used in hydraulics, hydronics and/or HVAC to express the relationship between variables involved in pump or fan performance (such as head, volumetric flow rate, shaft speed) and power. They apply to pumps, fans, and hydraulic turbines.
The reciprocating motion of a non-offset piston connected to a rotating crank through a connecting rod (as would be found in internal combustion engines) can be expressed by equations of motion. This article shows how these equations of motion can be derived using calculus as functions of angle (angle domain) and of time (time domain).
For empty freight cars with axle loads of 5.5 tonnes, Crr goes up to 0.00020 at 60 km/h but at a low speed of 20 km/h it increases to 0.00024 and at a high speed (for freight trains) of 120 km/h it is 0.00028. The Crr obtained above is added to the Crr of the other components to obtain the total Crr for the wheels.