Search results
Results from the WOW.Com Content Network
Drainage gradient (DG) is a term in road design, defined as the combined slope due to road surface cross slope (CS) and longitudinal slope (hilliness). Although the term may not be used, the concept is also used in roof design and landscape architecture. If the drainage gradient is too low, rain and melt water drainage will be insufficient.
The grade (US) or gradient (UK) (also called stepth, slope, incline, mainfall, pitch or rise) of a physical feature, landform or constructed line refers to the tangent of the angle of that surface to the horizontal. It is a special case of the slope, where zero indicates horizontality. A larger number indicates higher or steeper degree of "tilt".
Steeper cants or cambers are common on residential streets, allowing water to drain into the gutter. Cross slope describes the slope of a roadway perpendicular to the centerline. If a road were completely level, water would drain off it very slowly. This would create problems with hydroplaning, and ice accumulation in cold weather.
Minimum lane width: The minimum lane width is 12 feet (3.7 m), identical to most US and state highways. Shoulder width: The minimum width of the left paved shoulder is 4 feet (1.2 m), and of the right paved shoulder 10 feet (3.0 m). With three or more lanes in each direction, both shoulders are to be at least 10 feet (3.0 m) wide.
Cross slope is the angle around a vertical axis between: the horizontal line that is perpendicular to the road's center line, and. the surface. Typical values range from 2 percent for straight segments to 10 percent for sharp superelevated curves. It may also be expressed as a fraction of an inch in rise over a one- foot run (e.g. inch per foot).
Grading in civil engineering and landscape architectural construction is the work of ensuring a level base, or one with a specified slope, [1] for a construction work such as a foundation, the base course for a road or a railway, or landscape and garden improvements, or surface drainage. The earthworks created for such a purpose are often ...
The cant of a railway track or camber of a road (also referred to as superelevation, cross slope or cross fall) is the rate of change in elevation (height) between the two rails or edges of the road. This is normally greater where the railway or road is curved; raising the outer rail or the outer edge of the road creates a banked turn, thus ...
In modern mapping, a topographic map or topographic sheet is a type of map characterized by large- scale detail and quantitative representation of relief features, usually using contour lines (connecting points of equal elevation), but historically using a variety of methods. Traditional definitions require a topographic map to show both ...