Search results
Results from the WOW.Com Content Network
An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine. Systems commonly controlled by an ECU include the fuel injection and ignition systems.
An ECU from a Geo Storm An electronic control unit ( ECU ), also known as an electronic control module ( ECM ), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle .
Of all the electronics in any car, the computing power of the engine control unit is the highest, typically a 32-bit processor. [citation needed] A modern car may have up to 100 ECU's and a commercial vehicle up to 40. [citation needed] An engine ECU controls such functions as: In a diesel engine: Fuel injection rate; Emission control, NOx control
These electronic systems typically work in conjunction with the engine control unit (in a similar way to road cars), and are responsible for operating electronic throttle control, clutch and gearshift actuation (via an electric, hydraulic, or pneumatic actuator), gearshift time and speed, sensors, switches, solenoids, and other hydraulic ...
Engine tuning is the adjustment or modification of the internal combustion engine or Engine Control Unit (ECU) to yield optimal performance and increase the engine's power output, economy, or durability. These goals may be mutually exclusive; an engine may be de-tuned with respect to output power in exchange for better economy or longer engine ...
Preliminary design work in EEC-IV started even before EEC-III was in production. Over time, there were many different modules designed around this processor. It is likely that more Ford vehicles were produced using Engine/Powertrain Control Modules (ECM/PCM) based on variations of this design than any other module that Ford has ever used.
What made this ECU special was the use of two crank sensors and one cam sensor. The ECU used one crank sensor to count the teeth on the starter ring for its RPM signal, and the other read a pin on the back of the flywheel for TDC reference. This ECU was first seen when the 20V turbo 5-cylinder engine (RR Code) was installed into the Audi Quattro.
The hot film MAF sensor works somewhat similar to the hot wire MAF sensor, but instead it usually outputs a frequency signal. This sensor uses a hot film-grid instead of a hot wire. [3] It is commonly found in late 1980s and early 1990s fuel-injected vehicles. The output frequency is directly proportional to the air mass entering the engine.