Search results
Results from the WOW.Com Content Network
For Windows, due to limitations of the drivers of the cards, it is unlikely that PCI or CardBus cards will work. However, ISA cards will work. For Linux, chances are high that all cards will work. [13] The Personal C64 is a Commodore 64 emulator that supports transfer to/from 1541 disk drive. It was developed in 1994–1997 by Wolfgang Lorenz. [14]
The Atari joystick port used a 9-pin male socket in the host system, and female connectors on the devices. Classic Atari peripherals used a teardrop shaped rounded plug that was easy to grip to make it easier to plug in. Almost all compatible devices used similar physical layouts, often to the point of copying the plug design outright.
The game port is a device port that was found on IBM PC compatible and other computer systems throughout the 1980s and 1990s. It was the traditional connector for joystick input, and occasionally MIDI devices, until made obsolete by USB in the late 1990s.
The "Base" Camera Link configuration carries signals over a single connector/cable. [1] [2] [3] The cable used is a MDR ("Mini D Ribbon") 26-pin Male Plug Connector, optimized by 3M for the LVDS signal. In addition to the 5 LVDS pairs transmitting the serialized video data (24 bits of data and 4 framing/enable bits), the connector also carries ...
The system bus was a wider and faster 128-bit memory bus called the 6XX bus. It was designed to be a system bus for multiprocessor systems where processors, caches, memory and I/O was to be connected, assisted by a system control chip. It supports both 32- and 64-bit PowerPC processors, memory addresses larger than 32 bits, and NUMA environments.
A connector plug with all 60 pins (such as a Molex 88766-7610 DVI-I splitter) does not fit into a properly keyed DMS-59 socket. A Dual-DVI breakout cable can be used in connection with two passive DVI-to-HDMI adapters to feed modern displays with HDMI inputs, while using a DMS-59 graphics card, since the DVI signals are electrically identical ...
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
TOSLINK (Toshiba Link) [3] is a standardized [4] optical fiber connector system. [5] Generically known as optical audio, the most common use of the TOSLINK optical fiber connector is in consumer audio equipment in which the digital optical socket carries (transmits) a stream of digital audio signals from audio equipment (CD player, DVD player, Digital Audio Tape recorder, computer, video game ...