Search results
Results from the WOW.Com Content Network
Additionally, bleed air is used to keep critical parts of the plane (such as the wing leading edges) ice-free. [6] Bleed air is used on many aircraft systems because it is easily available, reliable, and a potent source of power. For example, bleed air from an airplane engine is used to start the remaining engines. Lavatory water storage tanks ...
The bleed air comes from the engines but is bled from the engine upstream of the combustor. Air cannot flow backwards through the engine except during a compressor stall (essentially a jet engine backfire), thus the bleed air should be free of combustion contaminants from the normal running of the aircraft's own engines.
While modern engines with advanced control units can avoid many causes of stall, jet aircraft pilots must continue to take this into account when dropping airspeed or increasing throttle. A compressor anti-stall system is a compressor bleed system that automatically dumps away unwanted air to prevent compressor stalling. [5]
Bleed air systems are used by most large aircraft with jet engines or turboprops. Hot air is "bled" off one or more engines' compressor sections into tubes routed through wings, tail surfaces, and engine inlets. Spent air is exhausted through holes in the wings' undersides. A disadvantage of these systems is that supplying an adequate amount of ...
Low pressure (40–70 psi or 280–480 kPa), high volume air from the compressor section of the APU is bled off through a system of pipes to the engines where it is directed into the starting system. This bleed air is directed into a mechanism to start the engine turning and begin pulling in air. The starter is usually an air turbine type ...
The Pratt & Whitney J58 (company designation JT11D-20) is an American jet engine that powered the Lockheed A-12, and subsequently the YF-12 and the SR-71 aircraft. It was an afterburning turbojet engine with a unique compressor bleed to the afterburner that gave increased thrust at high speeds.
Some aircraft are equipped with pneumatic deicing boots that disperse ice build-up on the surface. These systems require less engine bleed air but are usually less effective than a heated surface. A few aircraft use a weeping wing system, which has hundreds of small holes in the leading edges and releases anti-icing fluid on demand to prevent ...
Cabin Pressure and Bleed Air Control Panels on a Boeing 737-800. Modern jetliners have environmental control systems (ECS) that manage the flow of cabin air. Outside air enters the engines and is compressed in the forward section of the engine, prior to the combustion section, ensuring no combustion products can enter the cabin.