Search results
Results from the WOW.Com Content Network
A signal at +4 dBu is equivalent to a sine wave signal with a peak amplitude of approximately 1.736 volts, or any general signal at approximately 1.228 V RMS. Peak-to-peak (sometimes abbreviated as p-p ) amplitude (V PP ) refers to the total voltage swing of a signal, which is double the peak amplitude of the signal.
The decibel watt (dBW or dB W) is a unit for the measurement of the strength of a signal expressed in decibels relative to one watt.It is used because of its capability to express both very large and very small values of power in a short range of number; e.g., 1 milliwatt = −30 dBW, 1 watt = 0 dBW, 10 watts = 10 dBW, 100 watts = 20 dBW, and 1,000,000 W = 60 dBW.
This is an example of a case where sensivity is defined as the minimum input signal required to produce a specified output signal having a specified signal-to-noise ratio. [2] This definition has the advantage that the sensitivity is closely related to the detection limit of a sensor if the minimum detectable SNR o is specified ( SNR ).
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
Audio engineers use dynamic range to describe the ratio of the amplitude of the loudest possible undistorted signal to the noise floor, say of a microphone or loudspeaker. [18] Dynamic range is therefore the signal-to-noise ratio (SNR) for the case where the signal is the loudest possible for the system. For example, if the ceiling of a device ...
dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels.For example, phase noise is expressed in dBc/Hz at a given frequency offset from the carrier. dBc can also be used as a measurement of Spurious-Free Dynamic Range between the desired signal and unwanted spurious outputs resulting from the use of signal converters such as a digital ...
Weak signal strength can also be caused by destructive interference of the signals from local towers in urban areas, or by the construction materials used in some buildings causing significant attenuation of signal strength. Large buildings such as warehouses, hospitals and factories often have no usable signal further than a few metres from ...
This is the ratio (usually expressed in dB) between the noise floor of the device with no signal and the maximum signal (usually a sine wave) that can be output at a specified (low) distortion level. Since the early 1990s it has been recommended by several authorities including the Audio Engineering Society that measurements of dynamic range be ...