Search results
Results from the WOW.Com Content Network
In the past when it was called GM-Saginaw Product Company (SPC) a cloverleaf casting symbol mark was cast onto the iron component. [ 1 ] [ 2 ] The location has been the primary source of engine block and cylinder heads for all of GM's engines, to include Oldsmobile, Pontiac, Cadillac, Chevrolet, Buick and GMC for most of the 20th century.
It contributed to the casting needs provided by Saginaw Metal Casting Operations and Defiance Foundry. After the Corvair was cancelled the factory switched to casting the engine block and cylinder heads for the Chevrolet 2300 engine used in the Chevrolet Vega GM H platform , the Iron Duke engine used in both the GM N platform and GM L platform ...
Starting around 1925 engine blocks and cylinder heads were now developed at each brand but were cast at Saginaw Metal Casting Operations. [3] In the mid-1960s, there were 8 separate families of GM V8 engines on sale in the USA. [4] [1] By the 1970s, GM began to see problems with their approach.
GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983). These use a Chrysler custom Torqueflite 904 automatic transmission with an integral Chevrolet bellhousing.
All Oldsmobile V8s were assembled at plants in Lansing, Michigan while the engine block and cylinder heads were cast at Saginaw Metal Casting Operations. All Oldsmobile V8s use a 90° bank angle, and most share a common stroke dimension: 3.4375 in (87.31 mm) for early Rockets, 3.6875 in (93.66 mm) for later Generation 1 engines, and 3.385 in ...
GM also made extensive use of economies of scale for the LS: with the exception of the 4.8L and 7.0L engines, all variants used the same 3.622" stroke (with most of those variants using the same basic crankshaft casting), the 4.8L and 5.3L variants utilized the same block casting, and several variants used the same length connecting rod. [39]
In 1969 the 350 HO was upgraded again with the addition of the 400 HO cam, commonly referred to by enthusiasts as the 068 cam. Also added was the #48 casting number heads with a 68 cc (4.15 cu in) chamber for higher compression, along with larger 2.11 and 1.77 in (54 and 45 mm) valves.
These engines vary in displacement between 2.8 and 3.4 litres (2,837 and 3,350 cc) and have a cast-iron block and either cast-iron or aluminum heads. Production of these engines began in 1980 and ended in 2005 in the U.S., with production continued in China until 2010. This engine family was the basis for the GM High Value engine family.