Search results
Results from the WOW.Com Content Network
At the General Motors Motorama for 1954, Pontiac debuted its all new Bonneville Special, a concept car envisioned by head designer Harley J. Earl. The concept was equipped with the "Special"-8, a high output 268-cubic-inch (4.4 L) engine that was painted bright red and detailed in chrome.
RPO decoder (for newer vehicles). Beginning as early as 1967, [2] and to all their models since 1984, GM attached a Service Parts Identification (SPID) label. The label is most often located on the back of the glovebox door, on the inside of the trunk lid, or on the bottom of the spare tire cover.
Starting around 1925 engine blocks and cylinder heads were now developed at each brand but were cast at Saginaw Metal Casting Operations. [3] In the mid-1960s, there were 8 separate families of GM V8 engines on sale in the USA. [4] [1] By the 1970s, GM began to see problems with their approach.
In the past when it was called GM-Saginaw Product Company (SPC) a cloverleaf casting symbol mark was cast onto the iron component. [ 1 ] [ 2 ] The location has been the primary source of engine block and cylinder heads for all of GM's engines, to include Oldsmobile, Pontiac, Cadillac, Chevrolet, Buick and GMC for most of the 20th century.
GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983). These use a Chrysler custom Torqueflite 904 automatic transmission with an integral Chevrolet bellhousing.
The following year the motor became available in the compact Chevy II also. For the 1970 model year the 396 was bored 0.03 in (0.76 mm), resulting in a 402 cu in (6.6 L) engine. Despite this, the motor was still badged as a 396. 1970 was also the final production year for the L78.
These engines vary in displacement between 2.8 and 3.4 litres (2,837 and 3,350 cc) and have a cast-iron block and either cast-iron or aluminum heads. Production of these engines began in 1980 and ended in 2005 in the U.S., with production continued in China until 2010. This engine family was the basis for the GM High Value engine family.
The Chevrolet 90° V6 family of V6 engines began in 1978 with the Chevrolet 200 cu in (3.3 L) as the base engine for the all new 1978 Chevrolet Malibu.The original engine family was phased out in early 2014, with its final use as the 4.3 L (262 cu in) V6 engine used in Chevrolet and GMC trucks and vans.