Search results
Results from the WOW.Com Content Network
Reverse bias: Although the LED is based on a diode junction and is nominally a rectifier, the reverse-breakdown mode for some types can occur at very low voltages and essentially any excess reverse bias can cause immediate degradation, and may lead to vastly accelerated failure. 5 V is a typical maximum reverse bias voltage specification for ...
Even after the introduction of printed circuit boards, it did not require laying out and manufacturing circuit boards. Point-to-point and terminal strip construction continued to be used for some vacuum tube equipment even after the introduction of printed circuit boards. The heat of the tubes can degrade the circuit boards and cause them to ...
In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED. The voltage drop across a lit LED is approximately constant over a wide range of operating
But the need for digit read-out arose with electronic computers in the 1950s with many independent inventions, both in edge-lighting, nixie tubes and other technologies. U.S. patent 2,751,584 for an edge-lit multi-layer digit "Visual readout device" was filed on November 10, 1953, by inventor Carl L. Isborn of Hawthorne, California, for the ...
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
An Automated Optical Inspection device. Automated optical inspection (AOI) is an automated visual inspection of printed circuit board (PCB) (or LCD, transistor) manufacture where a camera autonomously scans the device under test for both catastrophic failure (e.g. missing component) and quality defects (e.g. fillet size or shape or component skew).
For similar reasons, a technique called trace necking reduces (or necks down [7] [8] [9]) the width of a trace that approaches a narrower pad of a surface-mounted device or a through-hole with a diameter that is less than the width of the trace, or when the trace passes through bottlenecks (for example, between the pads of a component).
In electronics, a signal trace or circuit trace on a printed circuit board (PCB) or integrated circuit (IC) is the equivalent of a wire for conducting signals. [1] [2] Each trace consists of a flat, narrow part of the copper foil that remains after etching. Signal traces are usually narrower than power or ground traces because the current ...