Search results
Results from the WOW.Com Content Network
Wire diameter can be as small as 20 μm (0.79 mils) and the geometry precision is not far from ± 1 μm (0.039 mils). The wire-cut process uses water as its dielectric fluid, controlling its resistivity and other electrical properties with filters and PID controlled de-ionizer units. The water flushes the cut debris away from the cutting zone.
Based in Houston, the Houston-Galveston Area Council is a member of the Texas Association of Regional Councils. Its service area is 12,500 square miles and contains more than 6 million people in Southeast Texas. H-GAC is the regional organization through which local governments consider issues and cooperate in solving area-wide problems.
Certain 1981–83 models used the EEC-III system, which uses a Dura-Spark III module (brown grommet where wires emerge) and a Dura-Spark II ignition coil. A resistance wire is used in the primary circuit. The distributors in EEC-III (and later) systems eliminate conventional mechanical and vacuum advance mechanisms. All timing is controlled by ...
The leader effectively projects the electrical field from the nearby electrode further into the gap, similar to introducing a short length of wire into the gap. The tip of the conductive leader now forms a new region from which streamers can extend even further into the gap.
An ignition magneto (also called a high-tension magneto) is an older type of ignition system used in spark-ignition engines (such as petrol engines). It uses a magneto and a transformer to make pulses of high voltage for the spark plugs. The older term "high-tension" means "high-voltage". [1]
Four spark plug wires (distributor end on the right, spark plug end on the left) Spark plug wires (also called high tension leads) are electrical cables used by older internal combustion engines to transmit high-voltage electricity from the distributor to the spark plugs. Tension in this instance is a synonym for voltage. High tension may also ...
These tubes were made for home storage battery receivers manufactured during the early to mid-1930s; all have 2.0 volt DC filaments despite the 1-prefix, intended to distinguish them from the 2.5 volt AC heated tubes listed below 1A4-p – Remote-cutoff pentode; 1A4-t – Remote-cutoff tetrode
A trigatron is a type of triggerable spark gap switch designed for high current and high voltage (usually 10–100 kV and 20–100 kA, though devices in the mega-ampere range exist as well). It has very simple construction and in many cases is the lowest cost high energy switching option.