Search results
Results from the WOW.Com Content Network
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause. Each MCA-Jet valve and valve seat are ...
An order from the engineering department (to be followed by the production department or vendor) overriding/superseding a detail on the drawing, which gets superseded with revised information. Also called by various other names, such as engineering change order (ECO), engineering change notice (ECN), drawing change notice (DCN), and so on.
AAV – Annulus access valve; ABAN – Abandonment, (also as AB and ABD and ABND) ABSA – Alberta Boilers Safety Association; ABT – Annulus bore test; ACC – Air-cooled heat condenser; ACHE – Air-cooled heat exchanger; ACOU – Acoustic; ACP – Alkali-cosolvent-polymer; ACQU – Acquisition log; ACV – Automatic control valve
mean sea level: MSLW Max. Structural Landing Weight MSP Modes S-Specific Protocol MSSS Mode S-Specific Services MSTOW Max. Structural Take-off Weight MSZFW Max. Structural Zero Fuel Weight MTBF Mean time between failures: MTBSV Mean time between shop visit MTBUR Mean time between unscheduled removals MTOW maximum take-off weight: MTTF Mean time ...
Using the PRV method of control, means that the pressure of the feed oil must be below a critical value (usually controlled by other valves which can leak out excess oil back to tank if it exceeds the critical value). The valve opens at a certain pressure and oil is kept moving at a constant rate into the bearing chamber.
The rocker arms for the intake valve were widened on the valve end to accommodate the cartridge, which was equipped with a very soft valve spring in order to avoid wear on the camshaft intake lobe. Modifications to the head were thereby reduced as the Jet Valve negated the necessity for a three-valve-per-cylinder design.
Aerospace engineering – is the primary field of engineering concerned with the development of aircraft and spacecraft. [13] It has two major and overlapping branches: Aeronautical engineering and Astronautical Engineering. Avionics engineering is similar, but deals with the electronics side of aerospace engineering.
The quantity of bleed air flowing to the AC pack is regulated by the flow control valve (FCV). One FCV is installed for each PACK. A normally closed isolation valve prevents air from the left bleed system from reaching the right PACK (and vice versa), although this valve may be opened in the event of loss of one bleed system.