Search results
Results from the WOW.Com Content Network
The following table is split into two groups based on whether it has a graphical visual interface or not. The latter requires a separate program to provide that feature, such as Qucs-S, [1] Oregano, [2] or a schematic design application that supports external simulators, such as KiCad or gEDA.
While there are strictly analog [2] electronics circuit simulators, popular simulators often include both analog and event-driven digital simulation [3] capabilities, and are known as mixed-mode or mixed-signal simulators if they can simulate both simultaneously. [4] An entire mixed signal analysis can be driven from one integrated schematic ...
Figure 3 A supersonic nozzle leading into a constant area duct is depicted. The initial conditions exist at point 1. Point 2 exists at the nozzle throat, where M = 1. Point 3 labels the transition from isentropic to Fanno flow. Points 4 and 5 give the pre- and post-shock wave conditions, and point E is the exit from the duct.
A heated metal wire (sensor wire, or simply sensor) suspended in a gas will lose heat to the gas as its molecules collide with the wire and remove heat. If the gas pressure is reduced, the number of molecules present will fall proportionately and the wire will lose heat more slowly. Measuring the heat loss is an indirect indication of pressure.
Mixed-mode simulation is handled on three levels by CircuitLogix: (a) with primitive digital elements that use timing models and a built-in 12-state digital logic simulator, (b) with subcircuit models that use the actual transistor topology of the integrated circuit, and finally, (c) with In-line Boolean logic expressions. These two modeling ...
GNU Circuit Analysis Package (Gnucap) is a general purpose circuit simulator started by Albert Davis [1] in 1993. [2] It is part of the GNU Project. [3] The latest stable version is 0.35 from 2006. The latest development snapshot (as of July 2023) is from June 2023 and is usable.
The sensor circuit is supplied with constant current. A distinguishing feature of the IEPE principle is that the power supply and the sensor signal are transmitted via one shielded wire. Most IEPE sensors work at a constant current between 2 and 20 mA. A common value is 4 mA. The higher the constant current the longer the possible cable length.
It offers the ability to set up a circuit with a graphical user interface and simulate the large-signal, small-signal and noise behaviour of the circuit. Originally, Qucs was composed of a circuit simulator "qucs-core", now Qucsator, and a GUI for schematic entry and plotting. The usage patterns, as well as the emphasis on RF design, were ...