Search results
Results from the WOW.Com Content Network
Tectonic plate interactions are classified into three basic types: [1] Convergent boundaries are areas where plates move toward each other and collide. These are also known as compressional or destructive boundaries. Obduction zones occurs when the continental plate is pushed under the oceanic plate, but this is unusual as the relative ...
Continental-continental divergent/constructive boundary Oceanic divergent boundary: mid-ocean ridge (cross-section/cut-away view). In plate tectonics, a divergent boundary or divergent plate boundary (also known as a constructive boundary or an extensional boundary) is a linear feature that exists between two tectonic plates that are moving away from each other.
Map showing Earth's principal tectonic plates and their boundaries in detail. These plates comprise the bulk of the continents and the Pacific Ocean.For purposes of this list, a major plate is any plate with an area greater than 20 million km 2 (7.7 million sq mi)
Divergent boundary. Divergent boundaries (constructive boundaries or extensional boundaries). These are where two plates slide apart from each other. At zones of ocean-to-ocean rifting, divergent boundaries form by seafloor spreading, allowing for the formation of new ocean basin, e.g. the Mid-Atlantic Ridge and East Pacific Rise. As the ocean ...
Where the plates meet, their relative motion determines the type of plate boundary (or fault): convergent, divergent, or transform. The relative movement of the plates typically ranges from zero to 10 cm annually.
Extensional tectonics is associated with the stretching and thinning of the crust or the lithosphere.This type of tectonics is found at divergent plate boundaries, in continental rifts, during and after a period of continental collision caused by the lateral spreading of the thickened crust formed, at releasing bends in strike-slip faults, in back-arc basins, and on the continental end of ...
Each boundary type is associated with different geological marine features. Divergent plates are the cause for mid-ocean ridge systems while convergent plates are responsible for subduction zones and the creation of deep ocean trenches. Transform boundaries cause earthquakes, displacement of rock, and crustal deformation. [8] [27] [26] [28]
A special class of strike-slip fault is the transform fault when it forms a plate boundary. This class is related to an offset in a spreading center, such as a mid-ocean ridge, or, less common, within continental lithosphere, such as the Dead Sea Transform in the Middle East or the Alpine Fault in New Zealand. Transform faults are also referred ...