Search results
Results from the WOW.Com Content Network
The depth from which a hand pump will suck is limited by atmospheric pressure to an operating depth of less than 7 meters. [5] The height to which a hand pump will lift is governed by the ability of the pump and the operator to lift the weight in the delivery pipe.
Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...
A typical Mark II hand pump in India. The pump was designed in the 1970s in a joint effort between the Government of India, UNICEF, and The World Health Organization (WHO) to address the severe drought and a water shortage affecting India during that period and to prevent evacuation of villages to refugee camps. Prior to the pump's design, poor ...
If an NPSH A is say 10 bar then the pump you are using will deliver exactly 10 bar more over the entire operational curve of a pump than its listed operational curve. Example: A pump with a max. pressure head of 8 bar (80 metres) will actually run at 18 bar if the NPSH A is 10 bar. i.e.: 8 bar (pump curve) plus 10 bar NPSH A = 18 bar.
A historical fire engine pumped by hand with the water supply held in a tub or cistern on the wagon, the water supply delivered by a bucket brigade. The similar terms hand pumper or hand engine may be a handtub or could have a suction hose drafting water from an external source rather than a tub, but still pumped manually. Hard suction hose
A treadle pump is a human-powered suction pump that sits on top of a well and is used for irrigation. [1] It is designed to lift water from a depth of seven metres or less. The pumping is activated by stepping up and down on a treadle, which are levers, which drive pistons, creating cylinder suction that draws groundwater to the surfa
It is a type of suction dredge. A water dredge or water eductor may be used for the same purpose. [1] Typically, the airlift is constructed from a 3-metre to 10 metre long, 10 cm diameter pipe. A controllable compressed air supply vents into the inside, lower end of the pipe (The input end always being the lower end).
A spiral pump, sometimes called a Wirz pump or incorrectly Wirtz pump, is a low lift pump which is composed of a long piece of metal plating, which is wound into a coil and sealed at the top and back extremities so as to resemble a cylinder. The outer cavity serves as the inlet, while the inner (partial) tube serves as the outlet.