Search results
Results from the WOW.Com Content Network
If none of these forwarding rules is appropriate for a given destination address, the default gateway is chosen as the router of last resort. The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL ...
On Windows computers, the gateway address is configured using the TCP/IP Properties. The gateway address can be automatically determined using Dynamic Host Configuration Protocol (DHCP). DHCP allows a host to obtain network information from a server. The host contacts the server to obtain an IP address and Default Gateway address.
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.
The primary function of a router is to forward a packet toward its destination network, which is the destination IP address of the packet. To do this, a router needs to search the routing information stored in its routing table. The routing table contains network/next hop associations. These associations tell a router that a particular ...
Static routing may have the following uses: When using static address configuration (in the absence of DHCP or Router Advertisements) it can be used to provide a default route, forming a special case of the longest prefix match as it has a prefix length of zero and therefore always matches, and always matches last.
The IP forwarding algorithm is a specific implementation of routing for IP networks. In order to achieve a successful transfer of data, the algorithm uses a routing table to select a next-hop router as the next destination for a datagram. The IP address of the selected router is known as the next-hop address. [1] The IP forwarding algorithm ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
Each 1-bit denotes a bit of the address range which must remain identical to the given IP address. The IP address in CIDR notation is always represented according to the standards for IPv4 or IPv6. The address may denote a specific interface address (including a host identifier, such as 10.0.0.1 / 8), or it may be the beginning address of an ...