Search results
Results from the WOW.Com Content Network
V-belts need larger pulleys for their thicker cross-section than flat belts. For high-power requirements, two or more V-belts can be joined side-by-side in an arrangement called a multi-V, running on matching multi-groove sheaves. This is known as a multiple-V-belt drive (or sometimes a "classical V-belt drive").
In contrast to the letter series row-crop tractors, which were intended to straddle one or more rows in a field with high clearances and adjustable axles, the W tractors had fixed wheel widths and a generally lower profile with smaller rear wheels and wide front axles, since they were meant for plowing, orchards, wheatfields and other applications that did not require the row-crop features.
Four wool spinning machines driven by belts from an overhead lineshaft (Leipzig, Germany, circa 1925) The belt drives of the Mueller Mill, model and reality, in motionA line shaft is a power-driven rotating shaft for power transmission that was used extensively from the Industrial Revolution until the early 20th century.
It replaced the hemp and rope belt used on automobiles and industrial machinery at the time, and was a model for the common serpentine belt. The belt's success propelled the company to become the largest manufacturer of V-belts, a title it still holds. [2] [3] In 1919, the International Rubber Company changed its name to the Gates Rubber Company.
In accordance with industry trends of the early 1960s, the 560 was styled with squared-off lines by industrial designer Raymond Loewy. The 560 was powered by a Perkins Engines 269.5-cubic-inch (4,416 cc) four-cylinder diesel engine with a six-speed transmission.
A toothed belt, timing belt, cogged belt, cog belt, or synchronous belt is a flexible belt with teeth moulded onto its inner surface. Toothed belts are usually designed to run over matching toothed pulleys or sprockets. Toothed belts are used in a wide array of mechanical devices where high power transmission is desired.
A single belt (serpentine belt) accessory drive was introduced on the L05, the 5.0L L03, and the 4.3L V6 LB4 engines used in the 1988 GMT400 models, but not on the older R/V models (R/V models received the serpentine belt drive in 1989 when the front grille was facelifted in appearance to the GMT400 lineup).
The belt sway switch will stop the conveyor if the belt starts losing its alignment along the structure. The speed switch will stop the belt if the switch is not registering that the belt is running at the required speed. The belt rip switch will stop the belt when there is a cut, or a flap indicating that the belt is in danger of further damage.