Search results
Results from the WOW.Com Content Network
A rotor blade produces more lift in the advancing half. As a blade moves toward the direction of flight, the forward motion of the aircraft increases the speed of the air flowing around the blade until it reaches a maximum when the blade is perpendicular to the relative wind. At the same time, a rotor blade in the retreating half produces less ...
Contra-rotating, also referred to as coaxial contra-rotating, is a technique whereby parts of a mechanism rotate in opposite directions about a common axis, usually to minimise the effect of torque. Examples include some aircraft propellers , resulting in the maximum power of a single piston or turboprop engine to drive two propellers in ...
Contra-rotating propellers Contra-rotating propellers on the Rolls-Royce Griffon-powered P-51XR Mustang Precious Metal at the 2014 Reno Air Races. Aircraft equipped with contra-rotating propellers (CRP) [1] coaxial contra-rotating propellers, or high-speed propellers, apply the maximum power of usually a single piston engine or turboprop engine to drive a pair of coaxial propellers in contra ...
Standalone fans are usually powered by an electric motor, often attached directly to the motor's output, with no gears or belts. The motor is either hidden in the fan's center hub or extends behind it. For big industrial fans, three-phase asynchronous motors are commonly used, may be placed near the fan, and drive it through a belt and pulleys ...
Diagram of a fan disk Fan disk assembly diagram, showing one blade and attachment hardware Cross section of fan disk Failed fan disk recovered from the center engine of UAL 232. A fan disk is the central hub of a fan in a turbofan engine. Fan blades are attached to the fan disk, which is rotated by a shaft driven by a gas turbine. [1]
Single-rotor helicopters need a mechanism to neutralize the yawing movement produced by the single large rotor. This is commonly accomplished by a tail rotor, coaxial rotors, and the NOTAR systems. Tandem-rotor helicopters, however, use counter-rotating rotors, with each cancelling out the other's torque.
Figure 1: Components of a centrifugal fan An external motor belt driven inline centrifugal fan discharging inline to the exterior of a building through a duct. Unlike non-inline/non-concentric impeller casing design with a cutoff blade above, the concentrically symetric cylinder casing and impeller geometry of inline type redirects the outflow around so that it is parallel to the inflow of gases.
In a stationary hover, each rotor blade will experience the same airspeed at a constant RPM. In forward flight conditions, one rotor blade will be moving into the oncoming air stream while the other moves away from it. At certain airspeeds, this can create a dangerous condition in which the receding rotor blade stalls, causing unstable flight. [5]