enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Carriage bolt - Wikipedia

   en.wikipedia.org/wiki/Carriage_bolt

   Carriage bolt according DIN 603. A carriage bolt (also called coach bolt and round-head square-neck bolt) [1] is a type of bolt. It is also known as a cup head bolt in Australia and New Zealand. It is distinguished from other bolts by its shallow mushroom head and the fact that the cross-section of the shank, though circular for most of its ...

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw

4. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Carriage bolt - Bolt with a smooth rounded head and a square section to prevent turning ... standard for bolts 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (12.7 to 38.1 mm) in ...

5. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   National Pipe Taper Fuel (NPTF, also called Dryseal American National Standard Taper Pipe Thread, defined by ASME B1.20.3) is designed to provide a more leak-free seal without the use of PTFE tape (often referred to by the popular brand name "Teflon") or another sealant compound.

6. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   British Standard Whitworth. British Standard Whitworth (BSW) is an imperial-unit -based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF, BSP, BSCon, and BSCopper.

7. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...