enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Eye bolt - Wikipedia

   en.wikipedia.org/wiki/Eye_bolt

   Eye bolts. Machinery eye bolts are fully threaded and may have a collar, making them suitable for use with angular loads up to 45°. Eye bolts without a shoulder should not be used for angular loads. Heavy forged eye bolts with a continuous eye may be forged with an integral shoulder, allowing their use for heavy off-axis loads.

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   An elevator bolt is a similar to a carriage bolt, except the head (or foot, depending on the application) is thin and flat. There are many variations. [11] Elevator bolts are designed to be used for leveling appliances or furniture. eye bolt: An eye bolt is a bolt with a looped head.

4. Cranked eye bolt - Wikipedia

   en.wikipedia.org/wiki/Cranked_eye_bolt

   A cranked eye bolt is an eye bolt typically used as a structural tie down [1] in building construction where the eye of the bolt must be fastened to a point that cannot be directly below where the shaft would otherwise be fastened. This often occurs where a bearer must be tied down to a post or column but the bearer cannot be directly fastened ...

5. Lewis (lifting appliance) - Wikipedia

   en.wikipedia.org/wiki/Lewis_(lifting_appliance)

   The first outer leg is inserted into the lewis hole, followed by the second outer leg. The inner (parallel) leg is inserted last, pushing the outer legs into contact with the inside of the lewis hole. The shackle is unbolted, placed over the legs, and the bolt fastened through both the shackle eyes and the eye in the top of each leg.

6. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   torque controlled: the anchor is inserted into the hole and secured by applying a specified torque to the bolt head or nut with a torque wrench. A particular sub-category of this anchor is called wedge type. As shown in the figure, tightening the bolt results in a wedge being driven up against a sleeve, which expands it and causes it to ...

7. Clevis fastener - Wikipedia

   en.wikipedia.org/wiki/Clevis_fastener

   Normal bolts are manufactured to handle tension loads, whereas clevis pins and bolts are designed to withstand shearing forces. The sheering strength of a threaded bolt is determined by its inner thread diameter. Clevis pins should be closely fitted to the holes in the clevis to limit wear and reduce the failure rate of either the pin or the ...