enow.com Web Search

  1. Ads

    related to: deadman anchors for retaining walls metal building

Search results

  1. Results from the WOW.Com Content Network
  2. Tieback (geotechnical) - Wikipedia

    en.wikipedia.org/wiki/Tieback_(geotechnical)

    Tiebacks to reinforce a slurry wall at Ground Zero, New York. A tieback is a structural element installed in soil or rock to transfer applied tensile load into the ground. . Typically in the form of a horizontal wire or rod, or a helical anchor, a tieback is commonly used along with other retaining systems (e.g. soldier piles, sheet piles, secant and tangent walls) to provide additional ...

  3. Earth anchor - Wikipedia

    en.wikipedia.org/wiki/Earth_anchor

    Single helix earth anchors Guyed mast anchor. An earth anchor is a device designed to support structures, most commonly used in geotechnical and construction applications. Also known as a ground anchor, percussion driven earth anchor or mechanical anchor, it may be impact driven into the ground or run in spirally, depending on its design and intended force-resistance characteristics.

  4. Retaining wall - Wikipedia

    en.wikipedia.org/wiki/Retaining_wall

    Definition. A retaining wall is designed to hold in place a mass of earth or the like, such as the edge of a terrace or excavation. The structure is constructed to resist the lateral pressure of soil when there is a desired change in ground elevation that exceeds the angle of repose of the soil. [ 1 ]

  5. Earthquake-resistant structures - Wikipedia

    en.wikipedia.org/wiki/Earthquake-resistant...

    Earthquake-resistant or aseismic structures are designed to protect buildings to some or greater extent from earthquakes. While no structure can be entirely impervious to earthquake damage, the goal of earthquake engineering is to erect structures that fare better during seismic activity than their conventional counterparts.

  6. Mechanically stabilized earth - Wikipedia

    en.wikipedia.org/wiki/Mechanically_stabilized_earth

    A diagram of a mechanically stabilized earth wall as it would be modeled in a finite element analysis. Mechanically stabilized earth (MSE or reinforced soil) is soil constructed with artificial reinforcing. It can be used for retaining walls, bridge abutments, seawalls, and dikes. [1][2] Although the basic principles of MSE have been used ...

  7. Anchor plate - Wikipedia

    en.wikipedia.org/wiki/Anchor_plate

    Anchor plate. An anchor plate, floor plate[1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style.

  8. Screw piles - Wikipedia

    en.wikipedia.org/wiki/Screw_piles

    Screw piles, sometimes referred to as screw-piles, screw piers, screw anchors, screw foundations, ground screws, helical piles, helical piers, or helical anchors are a steel screw-in piling and ground anchoring system used for building deep foundations. Screw piles are typically manufactured from high-strength steel [1] using varying sizes of ...

  9. Geotechnical engineering - Wikipedia

    en.wikipedia.org/wiki/Geotechnical_engineering

    Precast concrete retaining wall. A typical cross-section of a slope used in two-dimensional analyzes. Geotechnical engineering, also known as geotechnics, is the branch of civil engineering concerned with the engineering behavior of earth materials. It uses the principles of soil mechanics and rock mechanics to solve its engineering problems.

  1. Ads

    related to: deadman anchors for retaining walls metal building