Search results
Results from the WOW.Com Content Network
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
Commonly, a decimal SI metric prefix (such as kilo-) is used with bit and byte to express larger sizes (kilobit, kilobyte). But, this is usually inaccurate since these prefixes are decimal, whereas binary hardware size is usually binary. Customarily, each metric prefix, 1000 n, is used to mean a close approximation of a binary multiple, 1024 n ...
The kilobyte is a multiple of the unit byte for digital information. The International System of Units (SI) defines the prefix kilo as a multiplication factor of 1000 (10 3); therefore, one kilobyte is 1000 bytes. [1] The internationally recommended unit symbol for the kilobyte is kB. [1]
10 1: 5.0×10 1 bit/s Positioning system Bit rate for transmissions from GPS satellites [3] 5.6×10 1 bit/s Text data Bit rate for a skilled operator in Morse code [4] 10 3: kbit/s 4×10 3 bit/s Audio data Minimum achieved for encoding recognizable speech (using special-purpose speech codecs) 8×10 3 bit/s Audio data Low bit rate telephone ...
For example, a kilobyte is actually 1024 bytes even though the standard meaning of kilo is 1000. And, mega normally means one million, but in computing is often used to mean 2 20 = 1 048 576. The table below illustrates the differences between normal metric sizes and the implied actual size – the binary size.
MB uses the SI decimal (base ten) system, but computers use 1 or 0, a binary (base two) system. Binary 2^10 (1024) is almost equal to the decimal 10^3 (1 000) so early on 1024 bytes was referred to as a kilobyte. This is only a 2.4% difference; however at larger scales, such as exabytes, the difference is near 20%.
10 Gbit/s: 1 GB/s: 2004 Enterprise Southbridge Interface (ESI) 8 Gbit/s: 1 GB/s: PCI Express 1.0 (×4 link) [l] 10 Gbit/s: 1 GB/s: 2004 AGP 4×: 8.533 Gbit/s: 1.067 GB/s: 1998 PCI-X 133: 8.533 Gbit/s: 1.067 GB/s: PCI-X QDR 16-bit: 8.533 Gbit/s: 1.067 GB/s: InfiniBand single 4× [23] 8 Gbit/s: 1 GB/s: RapidIO Gen1 4×: 10 Gbit/s: 1.25 GB/s ...
As 1024 (2 10) is approximately 1000 (10 3), roughly corresponding to SI multiples, it was used for binary multiples as well. In 1998 the International Electrotechnical Commission (IEC) published standards for binary prefixes , requiring that the gigabyte strictly denote 1000 3 bytes and gibibyte denote 1024 3 bytes.