enow.com Web Search

  1. Ads

    related to: best ring and pinion manufacturers

Search results

  1. Results from the WOW.Com Content Network
  2. Dana 44 - Wikipedia

    en.wikipedia.org/wiki/Dana_44

    This ring and pinion is significantly stronger with a better pinion to ring gear tooth contact patch and angle. It was typically used in the back of jeep JKs, Isuzus and Nissan pickups. This ring and pinion does share some components and can be adapted into an earlier Dana 44 but requires some work, different bearings and spacers.

  3. Differential (mechanical device) - Wikipedia

    en.wikipedia.org/wiki/Differential_(mechanical...

    Illustration of a ring-and-pinion differential for a rear-wheel drive vehicle Schematic diagram of a ring-and pinion differential. A relatively simple design of differential is used in rear-wheel drive vehicles, whereby a ring gear is driven by a pinion gear connected to the transmission.

  4. GM 10.5-inch 14-bolt differential - Wikipedia

    en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

    Larger ring and pinion versus the "14-bolt" axle, although the pinion lacks support bearings similar to the 14-bolt design. Selectable locking differential available on the 2014–present Ram Power Wagon. 11.8 AAM axle, optioned on Ram 3500 trucks with the High Output package

  5. Dana 60 - Wikipedia

    en.wikipedia.org/wiki/Dana_60

    Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1 ...

  6. Limited-slip differential - Wikipedia

    en.wikipedia.org/wiki/Limited-slip_differential

    ZF LSD – clutch stack visible on left ZF LSD – spider pinion shaft ramps visible. Torque sensing LSDs respond to driveshaft torque, so that the more driveshaft input torque present, the harder the clutches, cones or gears are pressed together, and thus the more closely the drive wheels are coupled to each other.

  7. Dana 70 - Wikipedia

    en.wikipedia.org/wiki/Dana_70

    The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.

  1. Ads

    related to: best ring and pinion manufacturers