Ads
related to: where are rocker panels locatedfreshdiscover.com has been visited by 100K+ users in the past month
temu.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A rocker arm is a valvetrain component that typically transfers the motion of a pushrod in an overhead valve internal combustion engine to the corresponding intake/exhaust valve. Rocker arms in automobiles are typically made from stamped steel, or aluminum in higher-revving applications. Some rocker arms (called roller rockers) include a ...
Quarter-panel (or rear quarter panel) refers to the panel at the back sides starting at the rear edge of the rearmost doors, bordered by at top by the trunk (boot) lid and at bottom by the rear wheel arches ending at the rear bumper. This is the opposite of the fender. Literally, the term originally referred to the rear quarter or the car's length.
Ladder frame pickup truck chassis holds the vehicle's engine, drivetrain, suspension, and wheels The unibody - for the unitized body - is also a form of a frame. A vehicle frame, also historically known as its chassis, is the main supporting structure of a motor vehicle to which all other components are attached, comparable to the skeleton of an organism.
The B-pillar is located between a vehicle's front and rear side glass, where it serves as a structural support of its roof. [4] The C-pillar is the rearmost on two- and four-door sedans and hatchbacks. [5] The D-pillar is the rearmost pillar on larger four-door vehicles such as station wagons and full-sized SUVs.
Quarter panel. A quarter panel (British English: rear wing) is the body panel (exterior surface) of an automobile between a rear door (or only door on each side for two-door models) and the trunk (boot) and typically wraps around the wheel well. The similar front section between the door and the hood (bonnet) is called a fender (front wing ...
This page was last edited on 3 August 2010, at 00:26 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike License 4.0; additional terms may ...
In a push-rod system, the rocker arms are placed at the highest point in the assembly. As such, the rod is under pressure as it transfers compression forces upwards into the rocker arms. In a pull-rod system however, the rocker arms are located between the upper and lower control arms, at the centre of the assembly.
The LaCrosse used more high-strength steel than its predecessors, as well as a magnesium cross-car beam behind the instrument panel, another cross-car beam behind the rear seats, steel reinforcements in the rocker panels, interlocking door latch system, high-strength steel door beams, and a double-thick Quiet Steel floor pan and firewalls.
Ads
related to: where are rocker panels locatedfreshdiscover.com has been visited by 100K+ users in the past month
temu.com has been visited by 1M+ users in the past month