Ad
related to: 200r4 transmission identification
Search results
Results from the WOW.Com Content Network
Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck applications. Also found in wide and narrow ratio configurations. Muncie SM319 transmission — 3-speed transmission physically identical to the Muncie SM318, with an added Borg Warner overdrive unit.
The original version of the transmission had a 27-spline input shaft (shared with the THM200C and 2004R) which was a common failure point. In 1984, the 700R4 designed for use behind Chevrolet small block V8s received a 30-spline input shaft similar to those found on TH400 transmissions and which also used a different torque converter than its 2 ...
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The 1985 4-4-2 used an OZ code THM 200-4R transmission (as did the 1983–84 Hurst/Olds). Both 1986 and 1987 4-4-2 used the KZF code THM 200-4R. The KZF removed much of the shift harshness of the original OZ coded transmissions, but were still firmer than the run-of-the-mill overdrive transmissions used in the rest of Oldsmobile's lineup.
1977–1990 Custom Cruisers were fitted with two different automatic transmissions. From 1977 until 1980, the 3-speed THM200 was the sole transmission. From 1981 through 1990, the THM200-4R 4-speed automatic with overdrive was added, as GM added a lock-up torque converter and a 0.67:1 overdrive ratio.
The 2012-2016 DPS6 Powershift transmission was used in the 2012–2016 Ford Focus and 2011–2016 Ford Fiesta sedans. This transmission is the subject of a massive number of lawsuits alleging Ford lied in order to sell cars Ford knew had defective transmissions. [8] 2008–present 6DCT450 Ford Powershift (MPS6) 6-speed wet clutch
2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and Bronco II. 4.0L was produced by Ford Cologne Germany (like the unrelated and the all-new metric Taurus/Sable FWD 3.0 V6).
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
Ad
related to: 200r4 transmission identification