enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ball valve - Wikipedia

   en.wikipedia.org/wiki/Ball_valve

   A ball valve is a flow control device which uses a hollow, perforated, and pivoting ball to control fluid flowing through it. It is open when the hole through the middle of the ball is in line with the flow inlet, and closed when it is pivoted 90 degrees by the valve handle, blocking the flow. [1]

3. Nipple (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Nipple_(plumbing)

   A chase nipple has male threads on one end only. The other end is a hexagon. The chase nipple passes through the knockouts of two boxes, and is secured by an internally threaded ring called a lock nut. [1] [2] Chase-Shawmut Company, of Boston, is the company which first produced chase nipples. [3]

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Valves are available in several types, based on design and purpose: Gate, plug, or ball valves – Isolation; Globe valve – Throttling; Needle valve – Throttling, usually with high precision but low flow; Butterfly or diaphragm valves – Isolation and throttling; Check valve – Preventing reverse flow (non-return)

5. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The sealants, where used, are typically thread seal tape thread sealant or a thread seal paste pipe dope (sometimes similar in composition to plumber's putty). Because the thread body is tapered (0.75 in/ft or 62.5 mm/m), a larger diameter keeps compressing into a smaller diameter and finally forms a seal (no clearance remains between the ...

6. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   Unified Inch Screw Threads (UNJ Thread Form) V Thread Form ASME B1.20.1-2013: Pipe Threads, General Purpose (Inch) Pipe Thread Form ANSI B1.20.3-1976 (R2013) Dryseal Pipe Threads (Inch) Pipe Thread Form ASME B1.20.7-1991 (R2013) Hose Coupling Screw Threads - Inch: Pipe Thread Form ASME B1.21M-1997 (R2013) Metric Screw Threads - MJ Profile: V ...

7. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   Royal Microscopical Society (RMS) thread, also known as society thread, is a special 0.8-inch diameter × 36 thread-per-inch (TPI) Whitworth thread form used for microscope objective lenses. Microphone stands: 5 ⁄ 8-inch 27 threads per inch (TPI) Unified Special thread (UNS, USA and the rest of the world)