Search results
Results from the WOW.Com Content Network
This engine family was Chrysler's first 60° V6 engine designed and built in-house for front wheel drive vehicles, and their first V6 not based on a V8. It was designed as a larger, more powerful alternative to the Mitsubishi 3.0 V6 in the minivans and debuted in 1989 for the 1990 model year.
Forced induction, and cylinder deactivation options were engineered into the engine design, but have not been implemented from the factory, remaining "on the shelf" as of 2016. [ 4 ] Insiders initially reported that the engine would come in four basic sizes (3.0, 3.3, 3.6, and 4.0 L), each offered in various states of tune .
At its debut in 1993, this engine produced 214 hp (160 kW) and 221 lb⋅ft (300 N⋅m) with an iron block and aluminium cylinder heads. The 3.5 L engine was redone entirely of aluminum in 1999 as the EGG high output, producing 247–253 hp (184–189 kW) at 6500 rpm with 250 lb⋅ft (339 N⋅m) of torque at 4000 rpm.
The Chrysler flathead engine is a flathead inline automotive engine manufactured by the Chrysler Corporation from 1924 through the early 1960s. It came in four-,six-, and eight-cylinder configurations and varying displacements, with both cast iron and cast aluminum cylinder heads. It was installed in Chrysler, DeSoto, Dodge, and Plymouth ...
The 265 cu in (4.3 L) was introduced in 1971 in the VH. It used a new cylinder block with a bigger bore diameter of 3.91 in (99 mm)—the same as many of the Chrysler small-block V8s—and a new cylinder head, having slightly more hemispherical shaped combustion chambers with larger valves.
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
The hemi head always has intake and exhaust valve stems that point in different directions, requiring a large, wide cylinder head and complex rocker arm geometry in both cam-in-block and single overhead cam engines (dual overhead cam engines may not have rocker arms). This adds to the overall width of the engine, limiting the vehicles in which ...
The 400 cu in (6.6 L) B engine was introduced in 1972 to replace the venerable 383, and were power-rated via the net (installed) method. Chrysler increased the bore size of the 383 to create the 400. Its bore of 4.342-inch (110.3 mm) was the largest used in any production Chrysler V8 at the date of its introduction.