Search results
Results from the WOW.Com Content Network
In earlier toilets, the cistern was located high above the toilet bowl and connected to it by a long pipe. It was necessary to pull a hanging chain connected to a release valve located inside the cistern in order to flush the toilet. Modern toilets may be close coupled, with the cistern mounted directly on the toilet bowl and no intermediate ...
As the tank water level drops, the float descends and actuates the fill valve. Water is fed to the tank to replenish its supply, and a smaller flow is directed into the overflow tube to refill the bowl. Once the flapper valve closes, the water flow from the fill valve continues until the tank level again reaches the fill line.
There are also dual-flush toilets that use a siphon valve operated by a lever rather than buttons, with a ≤ 6L full flush, and a ≤ 3L half-flush if the flush handle is held down [8] or released immediately after flushing. [9] Tipping bucket. The tipping bucket cistern can operate in a dual flush mode when the lever is rotated halfway 2.5/5 ...
Flush tanks or cisterns usually incorporate a mechanism to release water from the tank and an automatic valve to allow the cistern to be refilled automatically. This system is suitable for locations plumbed with 12.7 or 9.5 mm ( 1 ⁄ 2 or 3 ⁄ 8 inch) water pipes which cannot supply water quickly enough to flush the toilet; the tank is needed ...
The fill valve in a toilet water tank is a liquid level-actuated valve. When a high water level is reached, a mechanism shuts the valve which fills the tank. In some valve designs, the pressure of the flow fluid itself or pressure difference of the flow fluid between the ports automatically controls flow through the valve.
A ball valve is a flow control device which uses a hollow, perforated, and pivoting ball to control fluid flowing through it. It is open when the hole through the middle of the ball is in line with the flow inlet, and closed when it is pivoted 90 degrees by the valve handle, blocking the flow. [1]
Regulations for these check valves specify the design capabilities of the valve used, according to the hazard. Category 2 contamination may be prevented by a single check valve, but category 3 requires a double check valve (these are manufactured as a convenient single unit, or even integrated into tap (faucet) fittings). Category 5 requires an ...
Ballcock: often used as a water level controller (cistern) Bibcock: provides a connection to a flexible hosepipe; Blast valve: prevents rapid overpressuring in a fallout shelter or a bunker; Boston valve: three-part two-port check valve used on inflatable boats, air mattresses, airbeds etc.; available in two sizes, normal and small