enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Slip ratio (gas–liquid flow) - Wikipedia

   en.wikipedia.org/wiki/Slip_ratio_(gas–liquid_flow)

   There are a number of correlations for slip ratio. For homogeneous flow, S = 1 (i.e. there is no slip). The Chisholm correlation [2] [3] is: = The Chisholm correlation is based on application of the simple annular flow model and equates the frictional pressure drops in the liquid and the gas phase.

3. Table of specific heat capacities - Wikipedia

   en.wikipedia.org/wiki/Table_of_specific_heat...

   Note that the especially high molar values, as for paraffin, gasoline, water and ammonia, result from calculating specific heats in terms of moles of molecules. If specific heat is expressed per mole of atoms for these substances, none of the constant-volume values exceed, to any large extent, the theoretical Dulong–Petit limit of 25 J⋅mol ...

4. NTU method - Wikipedia

   en.wikipedia.org/wiki/NTU_Method

   Here, is the molecular weight of water (vapor), is the average molecular weight of air, is the partial pressure of air (not including the partial pressure of water vapor in an air mixture) and can be approximated by knowing the partial pressure of water vapor at the inlet, before dehumidification occurs, ,. From here, all of the previously ...

5. Water heating - Wikipedia

   en.wikipedia.org/wiki/Water_heating

   In comparison, a typical 230 L (60 US gal) tank electric water heater has a 4.5 kW (15,000 BTU/h) heating element, which at 100% efficient results in a heating time of about 2.34 hours. At $0.16/kWh the electricity would cost $1.68.

6. Slip factor - Wikipedia

   en.wikipedia.org/wiki/Slip_factor

   Mathematically, the Slip factor denoted by 'σ' is defined as the ratio of the actual & ideal values of the whirl velocity components at the exit of the impeller. The ideal values can be calculated using an analytical approach while the actual values should be observed experimentally. = ′

7. Coefficient of performance - Wikipedia

   en.wikipedia.org/wiki/Coefficient_of_performance

   Reducing the output temperature to around 30 °C (86 °F) which requires piped floor, wall or ceiling heating, or oversized water to air heaters. Increasing the input temperature (e.g. by using an oversized ground source or by access to a solar-assisted thermal bank [ 10 ] ).