enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wood shaper - Wikipedia

   en.wikipedia.org/wiki/Wood_shaper

   The standard US spindle shaft is 1 + 3 ⁄ 4 in (44 mm), with 3 ⁄ 4 or 1 ⁄ 2 in (19 or 13 mm) on small shapers and 30 mm on European models. Most spindles are tall enough to accommodate more than one cutter head, allowing rapid tooling changes by raising or lowering desired heads into position. Additional spindles can be fitted with pre ...

3. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   A related tool, called a spindle moulder (UK) or shaper (North America), is used to hold larger cutter heads and can be used for deeper or larger-diameter cuts. Another related machine is the pin router, a larger static version of the hand electric router but normally with a much more powerful motor and other features such as automatic template ...

4. Rasp - Wikipedia

   en.wikipedia.org/wiki/Rasp

   Rasps come in a variety of shapes—rectangular, round, and half-round—and vary in coarseness from finest, "cabinet", to most aggressive, "wood". [2] Farriers, for example, commonly use rasps to remove excess wall from a horse's hoof. They are also used in woodworking for rapidly removing material and are easier to control than a drawknife ...

5. Cutting tool (machining) - Wikipedia

   en.wikipedia.org/wiki/Cutting_tool_(machining)

   It specifies the form of the cutting edge. 1 means a symmetric cutting edge. If the value is smaller than 1 the form is called a waterfall. If the value is larger than 1 it is called a trumpet. Depending on the material being cut, feed rate and other factors, a cutting tool with the optimum K factor should be used.

6. Milling cutter - Wikipedia

   en.wikipedia.org/wiki/Milling_cutter

   Milling cutters may have from one to many teeth, with two, three and four being most common. Typically, the more teeth a cutter has, the more rapidly it can remove material. So, a 4-tooth cutter can remove material at twice the rate of a two-tooth cutter. Helix angle: The flutes of a milling cutter are almost always helical. If the flutes were ...

7. End mill - Wikipedia

   en.wikipedia.org/wiki/End_mill

   A variety of grooves, slots, and pockets in the work-piece may be produced from a variety of tool bits. Common tool bit types are: square end cutters, ball end cutters, t-slot cutters, and shell mills. Square end cutters can mill square slots, pockets, and edges. Ball end cutters mill radiused slots or fillets.